Skip to main content
12

Working at Height

Main law for this topic: Work at Height Regulations 2005.

What counts as work at height

•Work at height is work anywhere a person could fall a distance liable to cause injury, if precautions weren't taken.

•Using a permanent staircase in a building is not work at height.

**The hierarchy** (Work at Height Regulations 2005)

•Avoid work at height where it can be done another way, for example from the ground.

•Prevent falls — use an existing safe place, or equipment that prevents falls (guard-rails, scaffolds, MEWPs).

•Minimise the distance and consequences of a fall (for example safety nets).

•Work at height must be properly planned, supervised and done by competent people.

•You must report any defect that could endanger anyone, and use equipment as trained and instructed.

Edge protection

•Top guard-rail at least 950 mm above the edge.

•No gap of more than 470 mm between guard-rails and other edge protection.

•Toe-boards suitable to stop people, materials and objects falling.

•Flat roofs need a secure double guard-rail and toe-board. Tape or painted lines don't stop a fall.

•Roof eaves need edge protection.

Scaffolds and towers

•A scaffold must be inspected by a competent person before first use, then at least every 7 days, and after anything that could affect its safety (such as a storm).

•A platform you could fall 2 metres or more from must not be used unless inspected in the last 7 days.

•The inspection report must be written before the end of the working period and handed over within 24 hours.

•Mobile towers must be put up by a competent person following the manufacturer's instructions.

•Winds above 23 mph (Force 5) will affect a person's balance — plan roof work around the weather.

Ladders and stepladders

•Ladders aren't banned. They suit low-risk, short-duration work — minutes, not hours. If a task means more than 30 minutes on a ladder, use something else.

•No formal qualification is needed, but you must be competent.

•Leaning ladders: angle 1 in 4 (75°), secured (for example tied), extending at least 1 m (about three rungs) above the landing.

•Ladders over 9 m need rest platforms at suitable intervals.

•Keep three points of contact (a hand and two feet), and keep your belt buckle inside the stiles — don't overreach.

•Carry only light materials.

•Don't stand on the top three rungs of a leaning ladder.

•Stepladders: all four feet level on the ground, locks engaged. Side loading can tip them — tie them if it can't be avoided.

Fragile roofs and harnesses

•Treat every roof as fragile until a competent person confirms it isn't.

•Rooflights can be hard to see or painted over. Protect them with barriers or secured, labelled covers.

•Work from a platform beneath the roof where possible, with stagings, guard-rails and nets.

Harnesses

•Check your harness at the start of each shift.

•A detailed, recorded inspection is needed at least every 6 months — every 3 months if used often.