Lifting Operations
10 questions · Adaptive
How adaptive learning works
This session is built around you. Questions you find difficult will appear more often. Questions you have already mastered are shown less. The more you practise, the smarter your sessions become.
- → Get it right first time — +10 XP
- → Get it right after a hint — +5 XP
- → Every question has a full explanation
Lifting Operations
53 questions in this chapter
Under LOLER, how must every lifting operation be organised?
Answer: Properly planned by a competent person, appropriately supervised, and carried out safely
What must be clearly marked on lifting machinery and lifting accessories?
Answer: Their safe working load (SWL)
What should never be exceeded when using lifting machinery or accessories such as chains and slings?
Answer: The safe working load
Which of these is a lifting accessory covered by LOLER?
Answer: A chain sling or a fibre rope sling
Which lifting equipment should you use?
Answer: Only certified equipment, marked with its SWL and not overdue for examination
How often must lifting accessories, such as slings, have a thorough examination?
Answer: At least every 6 months, or as set by an examination scheme
How often must lifting equipment used to lift people, such as a MEWP, be thoroughly examined?
Answer: At least every 6 months
How often must lifting equipment that is not used for people, and is not an accessory (such as a crane), be thoroughly examined?
Answer: At least every 12 months, or as set by an examination scheme
Who should take charge of attaching loads and signalling to the crane operator?
Answer: A responsible slinger or banksman, using a recognised signalling system
Who must be trained and competent in construction lifting operations?
Answer: Crane operators, and people who sling loads and direct lifting operations
What happens to the load in each leg of a multi-leg sling as the angle between the legs gets wider?
Answer: It increases
Before lifting an unbalanced load, what does HSE advise?
Answer: Find its centre of gravity, raise it a few inches and pause
You are unsure how much a load weighs, or whether the lifting gear is up to it. What should you do?
Answer: Don't lift it until you are sure
When should outriggers be used on lifting equipment?
Answer: Where necessary to keep the equipment stable
Lifting equipment is not designed for lifting people but might be used for it by mistake. What does LOLER require?
Answer: It must be clearly marked to show it is not for lifting people
Who should plan a lifting operation?
Answer: A competent person with adequate practical and theoretical knowledge and experience of the lifts
Who must be told if a thorough examination of lifting equipment finds a dangerous defect?
Answer: The user of the equipment and the enforcing authority
Which of these is a main hazard of lifting operations on site?
Answer: The load falling
How should lifting equipment be positioned?
Answer: To reduce the risk of the load striking someone or falling, as far as reasonably practicable
What kind of hook should be used on a gin wheel?
Answer: A proper hook designed to stop the load coming off, or one with a safety catch
Which of these does HSE say a gin wheel needs?
Answer: A secure anchorage, a safe platform for loading the hook, and a marked safe working load
A hoist is marked for goods only. Can you ride on it to save climbing the stairs?
Answer: No — passengers must never ride on a goods-only hoist
How often does HSE say construction hoists should have a formal inspection?
Answer: At least monthly, or more often if the manufacturer says so — plus daily pre-use checks
When should the landing gates on a hoist be open?
Answer: Only while the platform is being loaded or unloaded
Who should put up (erect) a construction hoist?
Answer: Only trained, experienced people, following the manufacturer's instructions
How should loose materials be carried on a hoist platform?
Answer: In secured containers, with the load spread evenly
What does HSE say are the two main hazards of using cranes on construction sites?
Answer: The crane collapsing, and loads falling
What authority must a crane supervisor have?
Answer: The authority to stop a lift they think is dangerous
A firm hires a crane but does not have the competence to plan and supervise the lift. What does HSE say it should do?
Answer: Opt for a contract lift, where the hire company takes on those duties
The plan for a crane lift is recorded in a method statement. Who needs to understand it?
Answer: Everyone involved in the lift
As well as its safe working load, what must equipment for lifting people be marked with?
Answer: The number of people it can lift
Apart from the regular intervals, when else does LOLER require lifting equipment to be thoroughly examined?
Answer: Each time exceptional circumstances occur that could put its safety at risk
What does LOLER say about a person who becomes trapped in the carrier of equipment for lifting people?
Answer: They must not be put in danger as a result, and must be able to be freed
A thorough examination finds a dangerous defect in a hoist. When can it be used again?
Answer: Not until the defect has been put right
When must a thorough examiner send a copy of their report to the enforcing authority?
Answer: When a defect involves an existing or imminent risk of serious personal injury
A simple pallet truck only raises its load just clear of the ground. Which regulations cover it?
Answer: PUWER, not LOLER
Does LOLER apply to a business whose workers use lifting equipment it does not own, such as a hired crane?
Answer: Yes — it applies to any business whose employees use lifting equipment, owned or not
Under LOLER, what else must be strong enough, apart from the lifting equipment itself?
Answer: Every part of the load, and anything attached to it for lifting
Who usually arranges the thorough examination of a hired crane, and what must the user do?
Answer: The hire company usually arranges it, but the user must make sure it is done and reports are in order
How often must a lift used to carry people at work be thoroughly examined, unless an examination scheme says otherwise?
Answer: At least every 6 months
How often must a goods-only lift be thoroughly examined, unless an examination scheme says otherwise?
Answer: At least every 12 months
Apart from the regular interval, when must a lift be thoroughly examined again?
Answer: After exceptional circumstances that could affect its safety
A thorough examination finds a lift defect that could become dangerous. When must the examiner tell the employer?
Answer: Forthwith
A lift has a defect with a risk of serious injury. Who else gets a copy of the report?
Answer: The relevant enforcing authority
Which law covers the safety of escalators and moving walkways at work, instead of LOLER?
Answer: Regulation 19 of the Workplace (Health, Safety and Welfare) Regulations 1992
How often does the escalator guidance recommend a thorough examination?
Answer: Normally every 6 months
Which regulations cover the design and installation of a new conventional passenger lift?
Answer: The Lifts Regulations 2016
When dismantling a lift, what stored energy must the plan take into account?
Answer: Suspended masses in the counterweights, lift car and ropes
If suspended lift parts must be released under load, what does HSE say is needed?
Answer: A remote method with robust exclusion zones
Which areas should exclusion zones cover when lift parts are released?
Answer: Lift landings, especially the lowest, the lift well and spaces beneath it
Who should plan the dismantling of a lift?
Answer: Competent people who understand that lift and how it is built into the structure
What does the standard quoted by HSE say about lift equipment during dismantling?
Answer: It should not be allowed to free-fall
What does HSE say accident investigations found about lift dismantling and demolition?
Answer: Poor work practices are commonplace