Electrical Safety
Main law for this topic: Electricity at Work Regulations 1989.
Why electricity is dangerous
•Nobody is immune. Getting a shock and not being hurt is luck — a small change could make it serious.
•Damp conditions and lots of metalwork increase the risk of shock.
•Contact with overhead lines can kill at voltages as low as 230V.
Tools and supplies on site
•Use cordless tools, or tools on a 110V centre-tapped-to-earth supply — the most you can get to earth is 55V.
•DIY and household tools, plugs and cables aren't suitable for site conditions.
•Check tools and cables before use. Take damaged ones out of service — no makeshift repairs.
•For 230V equipment, HSE suggests a visual check every shift, a weekly inspection, and an inspection and test before first use and monthly after.
RCDs (residual current devices)
•An RCD switches off the supply quickly when it detects some faults. One rated at 30 mA or less can save your life; higher ratings give very limited protection.
•An RCD doesn't protect against every shock — always isolate before working on a circuit.
•Test RCDs regularly with the test button and remove faulty ones.
•An RCD plugged into a socket protects only what is plugged into that socket.
Working on electrical systems
•No one may work on or near a live conductor unless it is unreasonable for it to be dead, it is reasonable to work live, and suitable precautions are taken.
•Before refurbishment, isolate parts of the system that the work could damage.
•Lock each isolator, keep the keys with the person doing the work, and post warning notices.
•Prove conductors dead with proper test equipment before starting.
•If an installation looks unsafe: warn people away, switch off if safe to do so, and call a competent person.
•If someone is working unsafely: ask them to stop, tell a manager, and tell HSE if it's still unsafe.
Overhead power lines
•Find out if there are lines in or near the work area, and treat them as live unless the owner proves otherwise.
•Lines on wooden poles are not necessarily telephone wires.
•You don't have to touch a line — electricity can "flash over" if you get too close. Damp or dirty wood or plastic can conduct.
•Tall or long equipment is the biggest risk: tippers, excavators, MEWPs, cranes and scaffold poles.
•Best: avoid working near lines, or have them diverted or made dead.
•Otherwise: barriers, goal posts and warning notices, with crossing points as narrow as safe and at right angles to the line. Get the safe clearance distance from the line owner.
•Don't cut trees near overhead lines yourself.
If plant touches a line
•Stay in the cab and call the network operator. If you can, drive clear or lower the part touching. Keep others away — anyone near live plant is at risk.
•If you must get out, jump clear — never touch the machine and the ground at the same time.
•Don't approach even if the power seems off — it can switch back on automatically.
•Plant touching an overhead line is reportable under RIDDOR.
Underground cables
•Cables often look like pipes — you can't tell if they're live by looking.
•Utility plans only give an idea of where services are. Use a cable locator often during the work, and dig trial holes by hand.
•Dig alongside a located cable, not on top of it, using insulated tools.
•With no plans (for example an emergency dig), work as if there are live services.
Sources
These notes are written in plain English from the law and official guidance below (checked November 2026).