Electrical Safety
All 91 free CSCS test practice questions and answers on Electrical Safety. Every question is our own, written from UK health and safety law and HSE guidance, and comes with an explanation.
Practise this topic interactively →
- Which power tools does HSE recommend for construction sites?
- On a 110V centre-tapped-to-earth supply, what is the maximum voltage to earth?
- Can tools, plugs and cables made for DIY and home use be used on site?
- You notice the cable on your power tool is damaged. What should you do?
- What does an RCD (residual current device) do?
- What rating of RCD gives useful protection against electric shock?
- If a circuit is protected by an RCD, can you work on it while it is live?
- How often should 230V equipment used on site have a visual check for damage?
- When is work on or near a live electrical conductor allowed?
- Refurbishment work could damage the building's existing electrics. What should happen first?
- Overhead power lines cross your work area. How should you treat them?
- Can you be hurt by an overhead power line without touching it?
- Where work under live overhead lines can't be avoided, what should be provided?
- What are the two best ways to remove the danger of overhead lines from a work area?
- The jib of your machine has touched an overhead power line. What should you do first?
- If you have to leave a vehicle that is in contact with an overhead line, how should you get out?
- A machine touched an overhead line and the power seems to have gone off. Is it safe to approach?
- Why are underground electricity cables particularly dangerous when digging?
- There are no plans showing buried services for an emergency dig. How should the work be done?
- How accurate are utility plans of underground services?
- How often should a cable locator be used during excavation work?
- How should you dig near a buried cable that has been located?
- What kind of tools should be used when hand digging near electric cables?
- You got a small electric shock last week and weren't hurt. What does HSE say about this?
- Which conditions does HSE say increase the risk of electric shock?
- You come across an electrical installation on site that looks unsafe. What does HSE say to do?
- How should an RCD be checked regularly?
- An RCD is plugged into one socket. Which equipment does it protect?
- Equipment has been isolated so that someone can work on it. What does HSE say should happen?
- Before work starts on conductors that have been isolated, what must be done?
- You see someone on site doing electrical work unsafely. What does HSE suggest?
- Overhead wires on wooden poles cross your site. What should you assume?
- Can damp or dirty wood or plastic conduct electricity?
- Which of these is at particularly high risk of touching overhead power lines?
- Plant has to cross under live overhead lines. How should the crossing passageway be set out?
- Who should you get the safe clearance distance for working under overhead lines from?
- At what voltage can contact with an overhead line be lethal?
- A tree near an overhead power line on site needs cutting back. What does HSE say?
- An excavator touches an overhead line and becomes live. Who is at risk?
- Plant on site touches an overhead power line, but nobody is hurt. Is this reportable under RIDDOR?
- HSE says an electric current can flow through the body from about what voltage?
- Which of these is a direct effect of an electric shock on the body?
- Why can a person who gets an electric shock be unable to let go of the live part?
- How does an electric current cause burns inside the body?
- You are working on a stepladder and get a small electric shock. What extra danger does HSE warn about?
- Which conditions make an electric shock more likely to injure you?
- Where could a single small torch battery cause a dangerous spark?
- What is the highest rating an RCD should have to give useful protection against electric shock?
- How should you check that an RCD is working?
- An RCD is fitted to the circuit you need to work on. What should you still do?
- According to HSE, how often should a user check 230V mains equipment on a construction site?
- How often does HSE suggest a combined inspection and test for 110V equipment on a construction site?
- Which of these is a sign that a power tool cable is not safe to use?
- You see burn marks and staining on a plug. What does this suggest?
- Are DIY or household extension leads suitable for use on a construction site?
- Who should repair a damaged power tool on site?
- Under the Electricity at Work Regulations, who may do electrical work where technical knowledge is needed to prevent danger?
- You are not sure how to check that a circuit is dead. What does HSE advise?
- What must happen before work on an electrical system starts, according to HSE?
- What should the isolation method do, as well as cutting off the supply?
- What is a good way to make sure an isolating switch stays off?
- Why is taking out a fuse not enough on its own to isolate a circuit?
- Before you use a voltage tester to check a circuit is dead, what must you be sure of?
- What does HSE warn about some cable detectors?
- An electrician was badly shocked because a supply had not been properly isolated. Under which law was the company prosecuted, as well as the Health and Safety at Work Act?
- What does HSE say about working on live electrical equipment?
- Under regulation 14 of the Electricity at Work Regulations, live working is only allowed when which of these is true?
- Your supervisor asks you to work live on a circuit just to save time. What should happen?
- Which tools does HSE recommend for construction sites to reduce the risk of electric shock?
- How often does HSE say RCDs on site should be checked?
- HSE says which type of power tool is the safest on a construction site?
- When can standard 13A socket outlets be used on a construction site?
- Can you use twin and earth cable to make an extension lead?
- A site cable crosses a roadway used by vehicles. How should it be laid?
- If a cable has to be suspended across a site road, what clearance does HSE give underneath it?
- Why should you never run a generator in an enclosed space?
- What is special about double-insulated (Class II) equipment?
- What is the danger if the earth connection on earthed (Class I) equipment is lost?
- What can high-power laser light do to your eyes?
- Who should carry out maintenance or repairs that give access to a laser?
- How does an employer decide if workers need protective eyewear for laser work?
- On a building site, what colour are 110V leads, plugs and sockets usually?
- Why must small offcuts of optical fibre be put in a proper waste container?
- Why should you never look into the end of an optical fibre?
- Three electricians are working on circuits from the same switched-off board. How should the isolator be kept off?
- When you prove a circuit is dead, what do you check first?
- Is a non-contact "voltage stick" enough on its own to prove a circuit is dead?
- What electrical protection does HSE say electric welding equipment needs?
- In stick (MMA) welding, where should the electrode holder be rested when not in use?
- How should the workpiece be earthed for arc welding?
- In MIG welding, what should the electrode wire be kept from touching?
How to revise Electrical Safety
Read through the questions and answers below, then practise this topic with instant explanations. Questions you get wrong are brought back later, so you spend your time on what you do not know yet. When you can answer most of them without looking, move on to the next topic.
How this topic appears in the test
The real test has 50 questions and you need 45 correct to pass. CITB doesn't publish how many come from each topic, so revise every topic, then take full mock tests to practise under the 45-minute time limit.
Questions from other topics
→ Legal Duties and Site Management (97 questions)→ Accidents, Emergencies and First Aid (44 questions)→ Health and Welfare (44 questions)→ Hazardous Substances and Dust (91 questions)→ Manual Handling (39 questions)→ Noise and Vibration (40 questions)→ Personal Protective Equipment (43 questions)→ Fire Prevention and Control (90 questions)→ Tools and Work Equipment (35 questions)→ Site Vehicles and Mobile Plant (68 questions)→ Working at Height (87 questions)→ Excavations and Confined Spaces (56 questions)→ Lifting Operations (53 questions)→ Environmental Awareness and Waste (45 questions)→ Safe Behaviour on Site (38 questions)→ Browse all 961 questions